North-star 5500 Bedienungsanleitung PDF herunterladen (Seite 8)

Hedge Trimmer 450

Home Computer 150 (a)

Impact Wrench 500

Jet Pump 800 (b)

Lawn Mower 1200

Light Bulb 100

Microwave Oven 700

Milk Cooler 1100 (b)

Oil Burner on Furnace 300

Oil Fired Space Htr (140,000 Btu) 400

Oil Fired Space Htr (85,000 Btu) 225

Oil Fired Space Htr (30,000 Btu) 150

Oven 4500

Paint Sprayer, Airless (1/3 HP) 600 (b)

Paint Sprayer, Airless (handheld) 150

Radio 200 (a)

Refrigerator 600 (c)

Slow Cooker 200

Submersibl e Pump (1-1/2 HP) 2800 (b)

Submersible Pump (1 HP) 2000 (b)

Submersibl e Pump (1/2 HP) 1500 (b)

Sump Pump 600 (b)

Table Saw (10”) 2000 (b)

Television 500 (a)

Toaster 1000

Vacuum cleaner 250

VCR 70 (a)

Water Heater 3000

Weed Trimmer 500

(a) Always use a voltage surge protector between

the generator and these voltage sensitive loads. To

order a surge protector call customer service at 1-

800-270-0810 and ask for item # 30793.

(b) Hard-starting motors require 3 to 5 times the

rated running watts.

restart due to its normal build up of compressor head

pressure.

NOTE: For extremely hard to start loads such as

air conditioners and air compressors, consult the

equipment dealer to determine the maximum wattage.

PRE-START PREPARATIONS

Your generator has been thoroughly tested prior to

shipment from the factory. A factory test report has

been included with this manual. However, damage

can occur during shipping, so be sure to check for

damaged parts or loose or missing nuts and bolts. If

the aforementioned problems occur, call customer

service at 1-800-270-0810.

GROUNDING - All units must be grounded. Dri ve

a 3/4” or 1” copper pipe or rod into the ground close to

the generator. The pipe/rod must penetrate moist

earth. Connect an approved ground clamp to the pipe.

Run a no. 12 Ga. wire from the clamp to the generator

grounding post located on the control panel. Do not

connect to a water pipe or a ground used by a radio

sy ste m.

CAUTION: The engine has been shipped without

oil. Fill the crankcase with oil before trying to start.

Low oil shut-down prevents your generator from

starting without sufficient oil.

OPERATING SPEED

The generator must be run at the correct speed in

order to produce the proper electrical voltage and

frequency. The speed of the engine was carefully

adjusted at the factory so that the generator produces

the proper voltage and frequency.

The output voltage should be checked to ensure

the generator is working properly before connecting a

load to the generator. Failure to do so could result in

damage to equipment pl ugged into the unit and

possible injury to the individual.

All engines have a tendency to slow down when a

load is applied. When the electrical load is connected

to the generator, the engine is more heavily loaded,

and as a result the speed drops slightly. This slight

decrease in speed, together with the voltage drop

within the generator itself, results in a slightly lower

voltage when the generator is loaded to its full capacity

than when it is running with no load. The slight

variation has no appreciable effect in the operation of

motors, lights and most appliances. Electronic

equipment and clocks will be affected if correct RPM is

not maintained. See Load vs. Output chart.

Load Output

Percent of

Generator

Output

Speed

(RPM)

Frequency

(Hz)

Generator

Voltage at 120V

Receptacle

0 % 3750 62.5 129V

50 % 3600 60.0 120V

100 % 3540 59.0 112V

Output voltage should be periodically checked to

ensure continued proper operation of the generating

plant and appliances, it can be checked with a portable

meter. Frequency can be checked using an electric

clock with a sweep second hand. Timed against a

wristwatch or a stopwatch the clock should be correct

within +/- 2 seconds per minute. Engine speed

adjustments should be done by a qualified technician.

BEFORE STARTING

1. Make sure the generator is positioned on firm

l e ve l surfa ce.

2. Check the crankcase for oil and maintain at a

proper level.

3. Check fuel level and fill tank 7/8 full with fresh

unleaded automotive gasoline. Never fill fuel tank

completely to the top. Always wipe up and remove

any spilled gasoli ne.

4. Make sure that the exhaust fumes are directed

away from people.

1 2 3 4 5 6 7 8 9 10

Kommentare zu diesen Handbüchern

Keine Kommentare

North-star 5500 Bedienungsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Generatoren North-star 5500